Trying to find Network ID, but there is not a "Network" tab under settings

Insight & Feedback
1

Installed the zimablade and drives. It is connected to an ethernet port on my netgear r6400v2 router, and I can verify the connection by opening the netgear app, and seeing it listed as a wired device under connected devices.

I try to install the client app, and it needs a network id. I am instructed to go to the settings tab, and click on the “network” tab. So, in my browser, i type the network IP address of the zimablade, and I see a web page that has all the controls, but when i click on settings, the network tab is no present. Does anyone know what I am missing? Thanks

2

The default OS for Zimablade is CasaOS. You need install ZimaOS to get the remote function.

This might be helpful: How to Install ZimaOS | Zimaspace Docs

3

Thanks for getting back, my familiarity with Linux type operating systems is limited to what I have gleaned from using Raspberry Pi for few years. Can I ask a couple of questions before I install ZimaOS? Will the drives I configured under CasaOS still be setup, or do I need to go through the setup again? And, is ZimaOS the secret needed to make my ZimaBlade available remotely? Thanks.

4

I see I was asking the wrong question… I want to close this thread, and open another one with the problem more fully stated.